Wiring Information For The Axb-Pt10 - AMX PT10-ADD Instruction Manual

Marker points
FIG. 9 Iris alignment with vertical tilt-axis
9. Mark the position of the cradle support bracket on the Tilt Hub (for later attachment).
10. Remove the camera/lens and mount piece from the support bracket by unscrewing the two ½"
screws on the underside of the camera mount.
11. Secure the support bracket to the Tilt Hub (at the same position marked for the iris alignment)
on the PT10 with some or all of the four ½" screws and washers.
12. Secure the camera/mount to the support bracket by using the two ½" screws.
The camera/lens cradle can be mounted on either side of the cradle support bracket. This is
especially useful when the camera is mounted to the ceiling.
13. Support the weight of the camera cables with a wire tie attached to the wire tie mount on the
lower corner of the face of the AXB-PT10 (FIG. 10).
When applying power to the AXB-PT10, adjust the soft-set pan/tilt-limit stops to a safe position to
prevent camera or AXB-PT10 damage.

Wiring Information for the AXB-PT10

Each PosiTrack Controller has an RS-232 DB-9 connector, lens control DB-15 high-density
connector, and an AXlink 4-pin connector. Always provide enough cable to accommodate the
desired range of motion for the PosiTrack unit and its camera/lens. The Lens Power switch on the
control panel (FIG. 10), removes any power noise on the incoming video by turning power On/Off
to Pin 1 of the DB-15 lens control connector when the camera/lens is powered from a separate
supply.
The AXB-PT10 receives all power through the +12 VDC and GND connections on the 4-pin
AXlink connector. The portion of the power directed toward the pan and tilt motors is fused. The
fuses are self-resetting.
The AXB-PT10 power rating is 2 amps @ 12 VDC. Refer to FIG. 11 for details.
PT10-ADD Additional Camera Pan/Tilt System
Iris
Installation and Wiring
Vertical tilt-axis
9