Wiring Information For The Axb-Em232; Putting It All Together - AMX PT10-PLV Instruction Manual

Installation and Wiring

Wiring Information for the AXB-EM232

FIG. 13 shows the front and rear view of the AXB-EM232 and describes the features relevant to
this configuration.
AXlink 4-pin captive-wire connector for data
and power (to AXB-PT10 and AXP-PLV)
FIG. 13 Front and rear views of the AXB-EM232
The following table describes the blink patterns for the front panel AXlink LED.
AXlink Blink Patterns
One blink/second
Two blinks/second
Three blinks/second
Full On

Putting It All Together

1. Connect the green 2-pin PS2.8 power connector to the rear of the AXB-EM232.
2. Make AXlink connections:
a. Connect the AXlink port on the AXB-EM232 to Connector 1 on the ABS.
b. Connect the AXlink port on the AXB-PT10 to open connector on the ABS.
c. Connect the mini-XLR port on the AXP-PLV to an open connector on the ABS.
3. Connect the CC-AXL 2-pin power connector to the PSN6.5 power supply.
When applying power to the AXB-PT10, adjust the soft-set pan/tilt-limit stops to a safe position to
prevent camera or AXB-PT10 damage.
4. Connect the lens control cable from the side of the lens to the 6-pin LENS connector on the
rear of the camera.
12
AXlink LED - The green AXlink LED blinks to indicate
AXlink communication activity, power, and data status,
according to the descriptions listed below.
TX1
RS-232
AXlink
PROGRAM
RX1
PROGRAM
RS-232 RS-232 / 422
Indicates that power is active and AXlink communication is functioning.
Indicates that power is active and AXlink communication is functioning, and that
the devices specified in the master program do not match the devices found. This
will be the blink pattern normally seen with PosiPilot camera control system
because the master program has the ability to control more devices than are nor-
mally present.
Indicates that there is an AXlink communication error.
Indicates that there is either no AXlink activity or that the AXCESS program is not
loaded.
TX2
RS-232 / 422
ON
1 2
RX2
12VDC
AXlink PWR
2-pin captive-wire 12 VDC
power connector (from PS2.8)
PT10-PLV Single Camera Pan/Tilt System