Sony HDR-XR100 Operating Instructions Manual page 144

HIGH (S:+)
Makes the flash level higher.
~
NORMAL (S:)
LOW (S:-)
Makes the flash level lower.
You can set this function when you record photos using the built-in flash, or an external flash
(sold separately) that is compatible with your camcorder.
When you set [REDEYE REDUC] to [ON], then set [FLASH MODE] to [AUTO] or [ON],
@
appears. You can prevent redeye by activating the pre-flash before the flash flashes.
Steps
A
(HOME) -;:; (SE,1TINGS) - [MOVIE SETTINGSl,- [FLASH LEVEL]
-a
desired-
setting
-+
[QR]-I
+=>
1,-00
~'ttASH
MODE
(HDR~XR200/XR200V)
' " - " - "'
Steps
A
(HOME}-;:; (SETTINGS}:.....[MOVIESETTIf'.JGSi-
[FLASH MODE]'L.
a desired
setting -
[QRl-I
+=>
!
-IX
I'
Steps .
A
(HOME)- ;:; (SETTINGS) .:..... [MOVIE SETTINGS]
'-+
[REDEYE REDUCl-
a
desired
setting:- [QEl-1
+=>
1- 00
You can set this function when you record photos using the built-in flash, or an external flash
(sold separately) that is compatible with your camcorder.
You can select the flash setting when you record photos using the built-in flash, or an external
flash (sold separately) that is compatible with your camcorder.
~ AUTO Automatically flashes when there is insufficient ambient light.
ON (S:) Always uses the flash regardless of the ambient brightness.
OFF
((t))
Records without flash.
(!)
Notes
• The recommended distance to the subject when using the built-in flash is about 0.3 to 2.5 m (1 to 8 feet).
• Remove any dust from the surface of the flash before using it. Flash effect may be impaired if heat
discoloration or dust obscures the lamp.
• You cannot set this item when a filter or a conversion lens is attached to your camcorder.
• The S:/CHG (charge) lamp (p. 8) flickers while charging the flash, and remains lit when the battery charge
is complete.
• If you use the flash in bright places such as when shooting a backlit subject, the flash may not be effective.
78