CanyCom CM1801 Operator's Manual page 21

6
HST lever
Aux. speed
change lever
Choke lever
Intermediate
speed
Engine control lever
<CM1801>
Fully Close
( )
High speed
Low speed
<CM1305>
OPERATION
Engine control lever
5. HST lever should be in "Neutral" position.
6. Aux. speed change lever should be in "Neutral" position.
In the case of CM 1801
7. Pull the choke lever and set it at the "Fully Close (
tion.
8. Adjust the accelerator lever in the neutral position between
"High speed" and "Low speed."
In the case of CM 1305
7. Move the accelerator lever to the "High speed" position.
Even when the engine is warm, be sure to set
the accelerator lever at the "High speed" posi-
tion when starting the engine.
– 16 –
N O T E
)" posi-