Supplying Power To The Rfs7000 Series Rf Switch - Motorola RFS7000GR Installation Manual

2.
On the configuration computer, configure a terminal emulation application
(such as HyperTerminal) as follows:
Terminal Type
Port
Terminal Settings

4.5 Supplying Power to the RFS7000 Series RF Switch

Rack mount
bracket
1.
Plug an approved AC power cord into the power connector at the back of the RFS7000 Series RF
Switch.
2.
Plug the cord into a standard AC outlet with a voltage range of 100 to 240 VAC.
.
WARNING!
VT-100
COM port
19200bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression
An improper shutdown can render the RFS7000 Series RF Switch
inoperable such that it could require service by Motorola Solutions
Support. Do not remove AC power without first following the shutdown
procedure. An abrupt loss of power can corrupt the information stored on
the device.
AC inlet
Installation Guide 17
sym_002