Telnet; Ftp - ZyXEL Communications NWA5121-N User Manual

The CLI screen displays next.
3

13.6 Telnet

You can use Telnet to access the NWA's command line interface. Click Configuration > System >
TELNET to configure your NWA for remote Telnet access. Use this screen to enable or disable Telnet
and set the server port number.
Figure 87 Configuration > System > TELNET
The following table describes the labels in this screen.
Table 63 Configuration > System > TELNET
LABEL
Enable
Server Port
Apply
Reset

13.7 FTP

You can upload and download the NWA's firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. See
about firmware and configuration files.
To change your NWA's FTP settings, click Configuration > System > FTP tab. The screen appears
as shown. Use this screen to specify FTP settings.
Chapter 13 System
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the NWA CLI using this service.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Click Apply to save your changes back to the NWA.
Click Reset to return the screen to its last-saved settings.
NWA5120 Series User's Guide
Chapter 15 on page 154
136
for more information