Function Display And Other - Epson PhotoPC 800 Service Manual

EPSON PhotoPC 800

1.3.4 Function Display and Other

†
LCD Monitor: 1.8 inch TFT color LCD monitor (110K pixels: 5142 x 218
pixels)
„
View rate at shooting:100%
„
Playback view range:100%
†
Beep Sound: Available (On/Off setting)
†
Self-Timer Indication:
„
Red lamp
„
Slow blink/fast blink
†
Control LCD Panel indicates;
„
the number of available pictures (3 digit)
„
the number of available pictures at quick shooting (Writing or shooting
up to 10 pictures)
„
Current exposure value
„
The setting of Image Quality mode
„
White balance mode
„
High Sensitivity mode
„
Flash mode
„
Low battery mark
„
Self-Timer mode
†
Lamp next to the VF (view finder)
„
Green light on/Green light blink/Off
†
Lamp in the rear
„
Red light on/Red light blink/Green light on/Green light blink/Orange
light blink/Off
†
Built-in clock: Year/Month/Date, Time/Minute/Second
Product Description
NOTE: However, Timer IC operates when the battery is installed. When
the batteries are exchanged, the time will be kept counted for 30-
minutes until the the electricity in the capacitor runs out.
†
Power Saving Function:Available to select the power save off time
10 seconds: Shuts down in 10 seconds
30 seconds: Shuts down in 30 seconds
1 minute:
3 minutes: Shuts down in 3 minutes
†
When using the slide show, it shuts down in one round.
†
Shuts down in 5 minutes when the camera is connected to PC, but the
camera does not shut down when using the USB connection.
†
No power saving function when using AC adapter.
†
Recover: escapes from the power saving function by half-shutter or turning
the power On again.
NOTE: No power saving when using the AC adapter.
This function works in 5 minutes when the camera is connected to
the PC.
Functions Specification
between 10 sec, 30 sec, 1 min or 3 min.
Shuts down in 1 minute
Revision A
14