4 Replacement Procedures
Installing the Cover assembly and Base assembly
To install the cover assembly and base assembly, follow the steps below and refer to Figure
4-24 to 4-25.
1. Place the cover assembly on the base assembly and engage the latches.
2. Connect the LCD cable, speaker cable and fingerprint sensor cable to the
connector CN5000, CN6170 and CN 9550 on the system board.
3. Secure the cover assembly with the following screws.
•
M2.5×6B
4. Close the display and turn over the computer.
5. Connect the USB cable to the connector CN4612 on the system board.
6. Secure the cover assembly with the following screws.
•
M2.5×6B
•
M2.5×16B
4-42 [CONFIDENTIAL] TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633)
FLAT HEAD screw
FLAT HEAD screw
FLAT HEAD screw
4.15 Cover assembly and Base assembly
×3
×8 ("6" in the figure 4-24)
×5 ("16" in the figure 4-24)