4 Replacement Procedures
Installing the Optical drive
To install the optical drive, follow the steps below and refer to Figure 4-20 and 4-21.
1. Set the mounting plate and secure it with the following screw.
•
M2×3C
2. Set the pushing plate and secure it with the following screws.
•
M2×2.7C
3. Insert the optical drive into the slot and push it until it is firmly connected to the
connector on the system board.
4. Turn over the computer and secure the optical drive with the following screw.
•
M2.5×6B
4-36 [CONFIDENTIAL] TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633)
S-THIN HEAD screw
S-THIN HEAD screw
FLAT HEAD screw
4.13 Optical drive
×1
×2
×1