Saving Power In Standby Mode; Enabling The Ir Repeater Function (When You Cannot Control The Tv) - Sony HT-RT5 Operating Instructions Manual

Saving Power in Standby
Mode
Check that you have made the following
settings:
– [Bluetooth Standby] is set to [Off]
(page 26).
– [Standby Through] is set to [Off]
(page 27).
– [Quick Start/Network Standby] is set to
[Off] (page 28).
– [Remote Start] is set to [Off] (page 29).
Enabling the IR Repeater
Function (when you
cannot control the TV)
When the Bar Speaker obstructs the
remote control sensor of the TV, the TV
remote control may not work. In that
case, enable the IR repeater function of
the system.
You can control the TV with the remote
together with the supplied IR blaster.
Note
• Be sure to check that the remote control of
the TV cannot control the TV, and then set
[IR-Repeater] to [On] (page 27). If it is set to
[On] when the remote control can control
the TV, appropriate operation may not be
obtained because of the interference
between the direct command from the
remote control and the command via the
system.
1
Connect the supplied IR blaster to
the IR BLASTER jack of the Bar
Speaker.
IR blaster
37
GB