When To Add The Bursts Of Steam; Preparing And Starting The Water Intake Process - Miele TX3587 Operating And Installation Instructions

When to add the bursts of steam

This option will only appear in the
display after you have selected 1, 2
or 3 bursts of steam.
Tip: If you have selected more than one
burst of steam, the 2nd one should be
released 10 minutes after starting the
programme at the earliest.
– Manual burst of steam
If you want to inject the bursts of steam
manually:
^ Select "Manual bursts of steam".
Then set the minute minder N to
remind you when to release them.
– Time-controlled bursts
If you want to time when to release the
bursts of steam:
^ Select "Time-controlled bursts".
^ Use the numerical keypad to set the
time for each burst of steam.
The oven will then release the steam
at the specified times. The time
counts down as soon as the
programme is started.
^ Select "OK".
The prompt to draw in water then
appears.
Moisture Plus d
Preparing and starting the water
intake process
^ Fill a suitable container with the
required amount of fresh tap water.
^ Open the door.
^ Pull the water intake pipe forwards
(located below the control panel on
the left).
^ Immerse the end of the water intake
pipe in the container with tap water.
^ Select "OK".
The water intake process begins.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
The intake process can be
interrupted and restarted at any time
by selecting "Stop" or "Start".
65