If you wish you can modify the pre-defined programs. Use the upper +/– buttons to increase/decrease
the temperature of each segment by 0.5° C. Use the lower +/– buttons to go forward/backward 30
minutes each time and copy the selected temperature value.
Settings
After commissioning you can change the date, time, temperature and time programming. By pressing
the upper +/– buttons you jump to the different menus.
1-3 = adjustment of date
2-3 = adjustment of time
3-3 = adjustment of time and temperature programming
3. You are now able to adjust the date as described in the initial start-up. The sequence of setting the
time is similar to the method for setting the date.
Rev: 02/15/004