Temperature Settings (Required Daytime Temperature, Required Set Back Temperature, Domestic Hot Water Temperature - Atag MadQ/2 User Manual

Temperature settings
Required daytime
temperature
Temperature
R R O O O O M M D D A A Y Y
m
2 2 1 1 0 0
change
Setting range: 5.0 ...30 °C
Factory preset: 21°C
accept
Required set back
temperature
during separate selection
pre-select heating circuit
first
R R O O O O M M N N I I G G H H T T
m
°C -1 1 6 6 0 0
Setting range: 5.0 ...30 °C
Factory preset: 16 °C
GB
DHW-temperature
D D H H W W
m
°C -6 6 3 3 0 0 °C
D D A A Y Y
Setting range: 10...80 °C
Factory preset: 63 °C
This button is used to set the desired room
temperature during the day
This button is used to set the desired room
temperature during the nightly set back
This button is used for the desired domestic
hot water temperature during the day
Adjustment (standard display mode only):
After pressing the button for the required tempe-
rature the current value appears flashing and can
be adjusted directly with the rotary pushbutton.
During separate selection, beforehand, select the
heating circuit for which the set day or set back
room temperature is valid (see page 27).
Re-entry into the standard display is accomplished
by touching the rotary pushbutton or automatically
after approx. 60 seconds.
Page GB-7