Table of Contents
Advertisement
3.
Press upper + button (– button disables the RF signal)
to enable a continuous RF signal. The receiver LED will
go out as soon as a signal from the transmitter is
received. Then press the OK-button, the radio link
between transmitter and receiver is now established.
Press the ESC-button to return to Auto mode.
4.
Receiver: When operating in heating mode and an ON
signal is received, the LED illuminates continuously.
When an OFF signal is received the LED will flash
intermittently.
4.
Display
Operating and adjustment
Operating information
• Flashing texts signal the need for an entry. If no button is pressed for 2 minutes, the device reverts
to the Automatic mode.
• All settings need to be confirmed with OK.
• All settings saved will remain in the memory.
The histogram shows the programmed temperature profile
•
7 – 14° C = displayed as one segment
15 – 24°C = one segment displays 1° C
over 24° C = one segment displays 2° C
A Current week day
B Battery
C RF signal
D Current time
E Set temperature
F Off mode
G Histogram over 24 hours
H Current temperature
I
Operating mode
J Status indication
K Current date
Rev: 02/15/004
Advertisement
Table of Contents
