Table of Contents
Advertisement
Installation
Important Note Before Starting
The Delano and the Hornet in wall receiver module (sold
separately) will only operate properly when all of the AC outlets
for the system and the displays in each zone are properly wired and
grounded.
Before installing anything, use an electrical outlet tester to verify
proper hot, neutral and ground wiring.
In the event your display has a two prong AC plug, it may be
necessary to connect the Hornet receiver's bracket to AC ground of
the AC outlet. See the Hornet installation instructions for further
information.
The Delano Matrix Switch has vents on the sides of the chassis.
Although the Delano has no direct airflow requirements, do not
block these vents. It is OK to place other equipment directly on top
of or below the Delano.
The Delano is equipped with padded feet so it may be stacked on
top of other equipment without causing damage. In either case, to
avoid scratches, never slide equipment on top of one another. The
feet may be removed with a Phillips screwdriver to make the
chassis exactly 2RU in height.
Unpacking
The shipping carton for the Delano matrix switch will include the
following items:
1 – Delano Matrix Switch
1 – AC Power cord
1 – 6' USB cable
5
Delano Matrix Switch User's Guide (DOC42-00022-A_NeoPro-Delano.doc)
Advertisement
Table of Contents
