Table of Contents
Advertisement
VGA interface connections
The mainboard's PCI SVGA interface can drive conventional CRT
displays and is capable of driving a wide range of flat panel
displays, including electroluminescent (EL), gas plasma, passive
LCD and active LCD displays. The card has two connectors to
support these displays, one for standard CRT VGA monitors and
one for flat panel displays.
CRT display connector (CN1)
CN1 is a 16-pin, dual-in-line header used for conventional CRT
displays. A simple one-to-one adapter can be used to match CN1
to a standard 15-pin D-SUB connector commonly used for VGA.
CRT display connector
Pin
1
2
3
4
5
6
7
8
When the mainboard's power is applied, the control signal is low
until just after the relevant flat panel signals are present.
Configuration of the VGA interface is done completely via the
software utility. You don't have to set any jumpers.
Signal
RED
GREEN
BLUE
N/C
GND
GND
GND
GND
Pin
Signal
9
VCC +5V
10
GND
11
N/C
12
DCC DAT
13
H-SYC
14
V-SYNC
15
DCC CLK
16
N/C
Chapter 2 Installation 35
Advertisement
Table of Contents
