OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the operation
selector with a pen to select the desired mode (COOL or
HEAT).
NOTE
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the operation
selector with a pen until the OPERATION lamp is turned off.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.
AWI MODELS
O P E R AT I O N
SELECTOR
FCI MODELS
OPERATION
SELECTOR
ASI MODELS
OPERATION
SELECTOR
SDI MODELS
OPERATION
SELECTOR
CARE AND CLEANING
WARNING
Maintenance operations must be carried out by specially
●
trained personnel.
●
For safety, be sure to turn the air conditioner off and also
to disconnect the power before cleaning.
●
Do not pour water on the indoor unit to clean it. This will
damage the internal components and cause an electric
shock hazard.
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
a mild liquid detergent.
When cleaning the grille, be careful not to force the vanes
out of place.
CAUTION
Never use solvents, or harsh chemicals when cleaning the
●
indoor unit. Do not wipe the plastic casing using very hot
water.
Some metal edges and the vanes are sharp and may
●
cause injury if handled improperly; be especially careful
when you clean these parts.
The internal coil and other components of the outdoor
●
unit must be cleaned every year. Consult your dealer or
service centre.
HOW TO REMOVE THE FRONT PANEL (ONLY FOR AWI-
ASI MODELS)
The front panel can be removed in order to wash it with
water.
AWI MODELS
●
With the front panel open all the way, grip both
arms with your hans and pull toward you to remove.
●
To remount, hold the front panel roughly horizontal
and push it in until the arm shafts fit into the indenta-
tions in the main unit, then fit the front panel into place.
ASI MODELS
GRILLE
Detach the safety string from the frame (remember to
●
attach it again after cleaning or maintenance).
Open the air intake grille , hold it on and pull it toward
●
you to detach the two guides.
11
Front
panel
STRING
EG