Table of Contents
Advertisement
Washing the grille with water
●
Clean the grille gently using a soft sponge, or the like.
Then wipe away any remaining moisture.
●
Neutral detergent may be used to remove stubborn
dirt. Then rinse thoroughly with water and wipe away
any remaining moisture.
ADDITIONAL MAINTENANCE (ONLY FOR ASI MODELS)
The inspection or replacement of internal components
involve the removal of the condensate drain pan.
EG
CAUTION
Some metal edges and the vanes of heat exchanger are
sharp and may cause injury if handled improperly; be
especially careful when you clean these parts.
HOW TO REMOVE THE CONDENSATE DRAIN PAN
RUBBER CORK
S U P P O R T
PLATE (2)
SCREW (4)
1.Open the air intake grille.
2.Drain the condensate water into a bucket trough the
rubber cork that should be soon closed.
3.Remove the frame-grille assembly by loosening the four
special screws with washer; you can utilise the two clips
that fix the frame to the unit.
4.Disconnect the electrical connectors between the frame-
grille assembly and the unit.
5.Remove the four screws of the two support plates.
6.Grasp the two support plates, remove with care the
condensate drain pan and clean it inside, if necessary.
7.Once finished the maintenance, reassemble the pan,
aligning the side with the hole for condensate drain and
the side with the pump; insert the connectors of the unit
into the proper hole in the pan.
8.Fix again the four screws of the support plates and the
frame group aligning the corner from which the wires exit
and the corner with the connectors of the unit.
9.Mount the air intake grille along with the filter; be sure
that the safety string has been attached and that the latch
screw has been fixed on both sides.
CONNECTORS
CONDENSATE
DRAIN PAN
CLIPS (2)
SPECIAL SCREW (4)
AIR FILTER
AWI-FCI MODELS
The filter behind thefront panel should be checked and
cleaned at least once every two weeks.
HOW TO REMOVE THE FILTER
AWI MODELS
Front panel
1. Grasp both ends of the front panel and pull it towards you
and up.
2. Push the filter up slightly, and then take it out. Clean the
air filter and replace it.
FCI MODELS
2
1.Grasp both ends of the air intake grille and pull to open
it.
2.Hold the air filter by the tab and pull it upward. Clean the
air filter.
3.When replacing the filter, make sure that the FRONT
mark is facing you. Reinsert the filter into place and close
the air intake grille.
ASI-SDI MODELS
The air filter should be cleaned at least once every six
months or more frequently; it depends on the real operation
conditions.
HOW TO REMOVE THE FILTER
ASI MODELS
L AT C H
SCREW
AIR INTAKE GRILLE
12
Air filter
1
3
AIR FILTER
Advertisement
Table of Contents
