Adjusting The Fan Speed; Night Mode/Energy Saving; High Power Mode; Fan Only - Technibel MTA8FIA0R5I Series Operating Instructions Manual

NOTE
Use DRY operation when you want to reduce the humidity
●
in the room.
● Once the room temperature reaches the set level, the unit
repeats the cycle of turning on and off automatically.
During DRY operation, the fan speed is automatically set
●
(Remote control lamp
Dry operation is not possible if the indoor temperature is
●
10 °C or less.
EG

FAN ONLY

If you want to make air circulate without any temperature
control, follow these steps:
1. Press the ON/OFF operation button and switch the air
conditioner ON.
2. Press MODE button until only the
appears on the display.

ADJUSTING THE FAN SPEED

AUTOMATIC
Simply set the FAN selector to the
microcomputer automatically controls the fan speed when
the AUTO mode is selected. When the air conditioner starts
operating, the difference between the room temperature
and the set temperature is detected by the microcomputer
which then automatically switches the fan speed to the
most suitable level.
WHEN DIFFERENCE BETWEEN
ROOM TEMPERATURE AND SET
TEMPERATURE IS
Cooling and
dehumidifying
modes:
Heating mode:
NOTE
The above mentioned data make reference to the
conditioner operating when the sensor on the remote control
unit is ON. (Refer to temperature sensor selector). If the
sensor on the indoor unit is being used then actual operation
will slightly differ from that described in the above tables.
The automatic speed is not available in FAN ONLY mode.
MANUAL
If you want to manually adjust speed just set the FAN selector
as desired.
High speed
is ON) to prevent overcooling.
FAN SPEED
2 °C and over
Between 2 and 1 °C Medium
Below 1 °C
2 °C and over
Below 2 °C Medium
Med. speed Low speed
FILTER Ti0
Pressing the FILTER button (symbol
the filtering system with titanium dioxide is activated; this
is very effective to prevent bad odours and to eliminate
bacteria and micro-organisms.
NOTE
The filter is active only if the internal fan is operating.
NIGHT MODE / ENERGY SAVING
● This mode enables you to save energy.
1. Set the MODE selector to cool, dry or heat.
2. Press the NIGHT button.
3. The
button again to release the NIGHT function.
fan sign
What does the NIGHT mode mean?
When you select the NIGHT mode, the air conditioner will
modify automatically the set temperature after 60 minutes.
This enables you to save energy without sacrificing your
comfort.
position.A
OPERATING MODE
Cooling and Dehumidifying
NOTA
During the NIGHT mode the internal fan speed is
automatically lower and reduces the noise.
COOLING AND DEHUMIDIFYING
Function selection
Selezione funzione
High
Room temperature
Low
High

HIGH POWER MODE

When this mode is active the internal fan speed is set
automatically and the air conditioner operates, for 15
minutes, at the maximum power. After 15 minutes from the
selection the symbol
mode is automatically switched off.
NOTE
During the high power operation the room temperature
could not correspond to the set temperature.
8
(if present)
2
mark appears on the display. Press the NIGHT
SET TEMPERATURE CHANGE
Heating Lowered by 1 °C
Temperatura ambiente
1°C
TIME TEMPO
1 h
Function selection
Selezione funzione
on the display switch off and the
on the display)
Raised by 2 °C
HEATING
Room temperature
Temperatura ambiente
2°C
TIME TEMPO
1 h