Table of Contents
Advertisement
The functional flap automatically closes when
●
NOTES
the unit is off.
The aesthetic flap automatically closes 3
●
minutes after the unit is switched off. (ONLY
FOR AWI MODELS)
When the unit starts in heating operation,
●
the fan speed will be low and the flap will be
in the 4 position until the air being blown out
of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
EG
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
AWI MODELS
Air outlet
grille
FCI MODELS
ASI MODELS
FLAPS
Up
Flap
Down
DEFLETTORE
HOW TO ADJUST THE FLAP DIRECTION
AWI MODELS
Zone «A»
for cooling and dehumidifyng
FCI MODELS
« A »
« B »
Zone «A»
for cooling and dehumidifyng
Zone «B»
for heating
CAUTION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
ASI MODELS
10
Zone «B»
for heating
« A »
« B »
40°
(ONLY AWI- FCI MODELS)
Zone «A» for cooling
and dehumidifyng
Zone «B»
for heating
Advertisement
Table of Contents
