PIAGGIO X7 250ie Service Station Manual page 127

X7 250ie
Engine
wear, replace the defective components with new
ones.
- Check there are no signs of wear on the auto-
matic valve-lifter cam, or the end-of stroke roller,
or the rubber buffer on the automatic valve-lifter
retaining cover.
- Check that the valve lifting spring has not yielded.
- Replace any defective or worn components.
- Check the rocker pins do not show signs of wear
or scoring.
- Measure the internal diameter of each rocker
arm.
Check there are no signs of wear on the pad from
contact with the cam and on the jointed adjustment
plate.
Characteristic
Internal rocker arm diameter: Standard diame-
ter
Diameter 12.000 - 12.011 mm
Rocker arm pin diameter: Standard diameter
Diameter 11.977 - 11.985 mm
Cam shaft check: Maximum admissible axial
clearance
0.42 mm
Cam shaft check: Standard axial clearance:
0.11 - 0.41 mm
Cam shaft check: Standard height
Outlet: 29.209 mm
Cam shaft check: Standard height
Inlet: 30.285 mm
Cam shaft check: Minimum admissible diame-
ter
Bearing B diameter: 19.950 mm
Cam shaft check: Minimum admissible diame-
ter
Bearing A Ø: 36.94 mm
Cam shaft check: Standard diameter
Bearing B diameter: 19.959 ÷ 19.98 mm
Cam shaft check: Standard diameter
ENG - 45