Defects - Malfunctions - Faema CARISMA S-1 Use And Installation

16. Defects - Malfunctions

Direct action by the customer
Before calling service personnel, to avoid useless expense, check whether the machine problem corresponds to one of the cases
listed below.
PROBLEM
The coffee machine is not working.
The machine does not dispense
coffee.
Leak from edge of filter-holder.
Coffee dispensing time too short.
Coffee drips out of machine.
Loss of water under the machine.
The machine display appears in
a different color and the "error"
message appears.
The enabled boiler resistance symbol
" ", remains visible on the display,
but the coffee machine does not
reach its operating pressure.
CAUSE
No electricity supply.
Water reservoir empty.
The undercup gasket is dirty with
coffee residue.
Coffee ground too coarse.
Coffee too old.
Filter holes blocked or filter holder
outlet hole dirty.
Coffee ground too fine.
Drain tray full.
The water filling phase in the boiler
or dispensing phase are particularly
prolonged.
Possible intervention of the safety
thermostat.
44
English
SOLUTION
Check the electricity supply.
Check that the plug is inserted into the socket and
that the line separator switch is closed
C h e c k t h e p o s i t i o n o f t h e O N / O F F
switch (1).
Check the color of the display and if the "no water"
icon has appeared.
Check the water level in the reservoir.
Clean with the supplied brush.
Use a finer grind.
Use new coffee.
Clean.
Use a coarser grind.
Empty the drain tray.
Check that the dispensing devices are enabled. Use
the general on-off switch (1) to turn off the machine
and then turn it on again.
Remove the tray; unscrew the safety cap and check
the position of the safety thermostat.
A
Thermostat in the Thermostat to be reset
correct working
position.
(*) To reset the thermostat, press the red switch until
it returns to its working position (Figure A).
If the anomaly continues after the device has been
reset, please contact the technical assistance
service.
English
(*).