First Start-Up - Faema CARISMA S-1 Use And Installation

2. First start-up

After making sure that at least 2 liters of water are in the water tank, follow these steps:
1
Press the main on/off switch at
the back of the machine.
Scalding hazard!
Warning: Do these steps very carefully.
4
Hook the filter holder (without coffee) to the group.
2
The display will light up with these indications:
Instant boiler pressure
Set pressure
Resistance enabled
Note: prolonged functioning of the
pump during the first start-up is
normal because the boiler is filled
with water during this phase.
3
The heating phase lasts approximately 3
minutes. Afterwards, the resistance icon
and "actual" pressures coincide.
5
Carisma S
Raise the coffee lever and
dispense water for a few
seconds. Afterwards, lower the
lever to the starting position to
stop dispensing.
That helps the temperature of the group and that of the filter to
match and it also rinses the hydraulic circuit.
32
English
~ 3 min
OK
is no longer displayed and the "set"
Carisma A
Press the coffee key
and dispense water for a few
seconds; press the same key
again to stop dispensing.
English