CipherLab 1660 User Manual page 42

1660/1661 Barcode Scanner
Send Data
When the memory is used up, the scanner will respond with two short beeps (high-low tone) as a
warning. You are advised to send data to the host immediately by having the scanner read the
"Send Data" barcode below.

For 1660, it will temporarily resume the previous WPAN connection with the host.
 For 1661, it can send data via "Direct USB" interface once the computer has found the USB
connection. Refer to
by default, you must connect the cable before having the scanner read the "Send Data"
barcode. Otherwise, the scanner will try to temporarily resume the previous WPAN connection
with the host, if there is any.
Send Data Time-out
For 1661, if a time-out value other than zero is given, it will first try to send data via "Direct USB"
interface within the specified period of time. You must connect the cable before it times out. When
the attempt fails, it will try to temporarily resume the previous WPAN connection with the host, if
there is any.
If 1661 has never been connected to the host wirelessly, it will not be able to send data until you
connect the Direct USB cable!
Clear Data & Confirm
Even though data has been sent back to the host, the flash memory is still occupied unless you
erase the memory by having the scanner read two barcodes – "Clear Data" and "Confirm".
1. Read the "Clear Data" barcode to clear the flash memory.
2. Read the "Confirm" barcode to confirm the action.
28
User Guide
1.13 1661 Using Direct USB
5 sec
8 sec
Cable. Because the time-out value is set to 0
Send Data
1661 Send Data
Time-0ut
after 0~15 sec.
(*0)
Clear Data
Confirm
Enter Setup