Connect Expansion Boxes To The System Unit; Attaching A System-Unit-To-Expansion-Box Cable To A Scsi; Connector On The System Unit - Digital Equipment DECstation 5000 Model 200 Operator's Manual

Connect Expansion Boxes to the System Unit

For each SCSI connector on the system unit, perform the
following steps:
If necessary, follow the instructions that came with your
1.
worksystem software to shut down the software.
Turn off the system unit and any expansion boxes.
2.
Position the small metal connector on the system-unit-to-
3.
expansion-box cable so the flat side of the connector is on
top, as shown in Figure 5-6.
Push the cable connector into the SCSI connector until it
4.
clicks into place.
Figure 5-6. Attaching a system-unit-to-expansion-box cable to a SCSI
External Storage Options: Hard Disk, Floppy Disk, Tape, and Optical Compact Disc Drives 5–9
Press the 0 on the on/off switch on the BA42 storage
expansion box, TK50Z tape drive expansion box, and
RRD40 optical compact disc drive expansion box.
Press and release the on/off switch on the TLZ04 tape
drive to turn it on and off.
SCSI connector
g i t a l
0

connector on the system unit

V~ 10 0-1
1
20 A 3.0
V~ 22 0-2
40 A 1.7
2
V~ 10 0-1
20 /22 0
A 7.9 /4.
2
Hz 50 -60
3
W 35 9
2
WSE2I061