Leica Rugby 620 User Manual page 35

Rugby 620, Troubleshooting
Problem Possible Cause(s)
Rugby does not The batteries are low or dead.
turn on.
The distance of the Dirt is reducing the laser output. Clean the windows of the
laser is reduced.
The laser receiver The Rugby is not rotating. It may
is not working be levelling or in Elevation Alert.
properly.
The receiver is out of usable
range.
The batteries of the receiver are
low.
Elevation Alert The Elevation Alert function is
function is not disabled.
working.
The Rugby does The Manual Mode is disabled.
not switch to
Manual Mode.
The Rugby beeps
three times when
the Auto-
matic/Manual
Mode button is
pressed and does
not change to
Manual Mode.
Suggested Solutions
Check the batteries and
change or charge the batteries
if necessary. If the problem
continues, return the Rugby to
an authorised service centre
for service.
Rugby and the receiver. If the
problem continues, return the
Rugby to an authorised service
centre for service.
Check for proper operation of
the Rugby.

Refer to the receiver
manual for more infor-
mation.
Move closer to the Rugby.
Change the receiver batteries.
The Elevation Alert function is
enabled or disabled by
pressing the following button
combination:
With Rugby turned on and
rotating, press and hold the Up
and Down Arrow buttons. Then
press the Automatic/Manual
Mode button to enable or
disable the Elevation Alert
function. The Rugby beeps
once to indicate the change.
The Manual Mode can be
enabled or disabled by
pressing the following button
combination:
With the Rugby turned off,
press and hold both the Auto-
matic/Manual Mode button
and the Power button for
5 seconds. The Rugby will beep
five times, then give a longer
beep at the end to indicate the
change.
35