ZyXEL Communications NBG6503 User Manual page 93

Note: You must enable the same wireless security settings on the NBG and on all wireless
clients that you want to associate with it.
The WDS feature is only available in wireless 2.4G network.
Click Network > Wireless LAN 2.4G > WDS tab. The following screen opens with the Basic
Setting set to AP+Bridge, and Security Mode set to WEP.
Figure 71 Network > Wireless LAN 2.4G > WDS
The following table describes the labels in this screen.
Table 41 Network > Wireless LAN 2.4G > WDS
LABEL DESCRIPTION
WDS Setup
Basic Settings Select the operating mode for your NBG.
• AP + Bridge - The NBG functions as a bridge and access point simultaneously.
• Bridge - The NBG acts as a wireless network bridge and establishes wireless links with
other APs. You need to know the MAC address of the peer device, which also must be in
bridge mode. The NBG can establish up to five wireless links with other APs.
Local MAC This is the MAC address of your NBG.
Address
Phy Mode Select the Phy mode you want the NBG to use. This dictates the maximum size of packets
during data transmission.
Remote MAC This is the MAC address of the peer device that your NBG wants to make a bridge connection
Address with.
You can connect to up to 4 peer devices.
Security
EncrypType Select whether to use WEP, TKIP or AES encryption for your WDS connection in this field.
Otherwise, select No Security.
EncrypKey The Encryp key is used to encrypt data. Peers must use the same key for data transmission.
Apply Click Apply to save your changes to NBG.
Cancel Click Cancel to reload the previous configuration for this screen.
Chapter 10 Wireless LAN
NBG6503 User's Guide
93