ZyXEL Communications NBG6503 User Manual page 103

Table 44 Network > WAN > Internet Connection: PPTP Encapsulation (continued)
LABEL DESCRIPTION
Nailed-up Select Nailed-Up Connection if you do not want the connection to time out.
Connection
Idle Timeout This value specifies the time in minutes that elapses before the NBG automatically
disconnects from the PPTP server.
PPTP Configuration
Server IP Type the IP address of the PPTP server.
Address
Get Select this option If your ISP did not assign you a fixed IP address. This is the default
automatically selection.
from ISP
Use Fixed IP Select this option If the ISP assigned a fixed IP address.
Address
IP Address Enter your WAN IP address in this field if you selected Use Fixed IP Address.
IP Subnet Your NBG will automatically calculate the subnet mask based on the IP address that you
Mask
assign. Unless you are implementing subnetting, use the subnet mask computed by the
NBG.
Gateway IP Enter a Gateway IP Address (if your ISP gave you one) in this field.
Address
WAN IP Address Assignment
Get Select this to get your WAN IP address from your ISP.
automatically
from ISP
Use Fixed IP Select this option If the ISP assigned a fixed IP address.
Address
My WAN IP Enter your WAN IP address in this field if you selected Use Fixed IP Address.
Address
WAN DNS Assignment
First DNS Select From ISP if your ISP dynamically assigns DNS server information (and the NBG's
Server WAN IP address). The field to the right displays the (read-only) DNS server IP address that
the ISP assigns.
Second DNS
Server Select User-Defined if you have the IP address of a DNS server. Enter the DNS server's IP
address in the field to the right. If you chose User-Defined, but leave the IP address set to
0.0.0.0, User-Defined changes to None after you click Apply. If you set a second choice
to User-Defined, and enter the same IP address, the second User-Defined changes to
None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not configure a DNS
server, you must know the IP address of a computer in order to access it.
WAN MAC The MAC address section allows users to configure the WAN port's MAC address by either
Address using the NBG's MAC address, copying the MAC address from a computer on your LAN or
manually entering a MAC address.
Factory default Select Factory default to use the factory assigned default MAC Address.
Clone the Select Clone the computer's MAC address - IP Address and enter the IP address of the
computer's computer on the LAN whose MAC you are cloning.
MAC address -
IP Address
Set WAN MAC Select this option and enter the MAC address you want to use.
Address
Apply Click Apply to save your changes back to the NBG.
Reset Click Reset to begin configuring this screen afresh.
Chapter 11 WAN
NBG6503 User's Guide
103