Table of Contents
Advertisement
front I/O plate
Hard Drive installation [S10V]
The S10V supports 2 hard drives. Each HD requires four anti-vibration screws,
as shown, which will isolate the drive from the chassis once installed
is push fitted over the mount screws on the one side only. The drive may then be positioned
between the chassis mounts as shown, and gently pushed into place, taking care not to
damage the rubber on the mount screws. One thumb screw will secure the hard drive in place.
mount
bracket
Optical disc drive installation [S10V]
Loosen (no need to remove) the 4 fixing screws
allow
the ODD bracket
heads. Install the ODD as shown.
standard 40 pin connecter. Before securing the drive screws, check
the ODD's position in the chassis - it should sit as close to the front I/O
plate as possible without the drive eject button becoming depressed.
Secure all fixing screws and check the eject button functions correctly.
12.7mm slot
load ODD
ODD
bracket
to slide up and be lifted out over the screw
The IDE adapter will allow for the
mount
screw
. Keyhole shaped holes
secured
. A single mount bracket
9
Hide quick links:
Advertisement
Table of Contents
