Opening The Case; Odd Cage Removal; Optical Disk Drive Installation - Origen ae S16T User Manual

1

ODD cage removal

Remove the top fixing screw completely.
Loosen (no need to remove) the
screws circled.
on the base of the cage allow
back and be lifted out over the screw
heads, ready for ODD installation.
4
2
4 fixing
Keyhole shaped holes
it to slide
front I/O plate
Hard drive
mount
Optical disc drive installation
Unclip the existing plastic drive bezel from your
ODD. The disc tray should be ejected for this and
usually requires some upward force to the bezel.
Slide the optical disk drive through the front of
the cage. Before securing the drive screws,
check/adjust the ODD's position in the chassis -
it should sit as close to the front I/O plate as
possible without the drive eject button becoming
depressed. Secure all fixing screws and double
check the eject button functions correctly.

Opening the case

Remove the thumb screws
as indicated. Carefully raise
the p anel as shown (about
30mm is enough) and
out to remove. Reverse the
procedure to replace.
DO NOT force upwards
as this could cause
damage to the top panel.
ODD
cage
Optical
disk drive
pull