Page 5
X11 overview X11 overview. Front view highlighting features and controls. External dimensions (WxHxD) 435x170x420mm Motherboard support ATX, micro ATX Drive bays 4 x 3.5” internal, 1 x 3.5” + 1 x 5.25” external 11 12 PSU support PCI / AGP card support...
Page 6
Opening the case / removing drive caddies Opening the case. To remove the lid of the case, undo the 5 screws indicated. Removing drive caddies. To install the hard drives, optical disk drive and 3.5” drive, the caddies need to be removed from the main chassis.
Page 7
Hard Drive 1 Drive installation and configuration procedure. The X11 can support up to 4 x hard drives, 1 x optical drive and 1 x 3.5” drive. When installing hard drives, it is recommended that they are populated in the order shown.
Page 8
Optical drive bezel installation Optical disk drive bezel installation. The X11 is supplied with an aluminum optical drive bezel to match the finish of the case. The installation procedure requires that the plastic drive bezel that comes fitted on your drive be removed and replaced with the aluminum X11 drive bezel.
Page 9
Front ports cable diagram Front ports cable diagram. VCC 1 The X11 provides front audio, DATA+ 1 USB1 USB, and 1394 ports DATA- 1 motherboards that support GROUND 1 these connections . There are 3 cables that can be VCC 2...
Page 10
VFD/IR cable diagram VFD/IR cable diagram. This is a general overview of the cable layout connecting the VFD/IR module, power switch (power button) and the motherboard. Please refer to your motherboard manual for the location of the correct ports and header pins. Power switch IN Power switch OUT Programming pin (do not use)
Page 11
VFD/IR module installation VFD/IR module installation procedure. This should be done once the motherboard has been fitted, and before the drive caddies are installed. Standby ATX power cable. This cable is required to draw a standby current from the PSU when the PC is off. This allows the IR module to function when the power is off, and turn the PC on remotely.
Page 12
VFD/IR Software Installation. You will require the CD provided to begin the installation of the VFD/IR software, and you should select the X11 option from the main menu to begin. There are 2 steps required to install the necessary software to operate the VFD/IR:...
Page 13
Installing VFD/IR driver Installing VFD/IR driver. Prior to running the VFD/IR software, the driver must be installed. This is done by following the procedure below. When the VFD/IR Make sure ‘Search for Browse to your ROM DRIVE and select the folder ‘VFD module is connected the best driver in these Driver’, then Click ‘OK’.
Page 14
Installing VFD/IR software Installing VFD/IR Software. The software installation is started by clicking the link shown on the Installation CD. Follow the steps below to complete the installation. Installing Software Select language. When the IR software is running, this icon will be displayed in the taskbar.
Page 16
Origen Contact Details #209 Baeksan B/D 763-2 Hengsin-Dong Dukyang-Gu Goyang City Gyounggi-Do 412-220 South Korea Global Product Support e-mail:support@origenae.com Website www.origenae.com...