For Your Security; What May Cause The Universal Transceiver Not To Work - Chrysler 2004 300M User Manual

3. Press the programming button on the garage door
opener motor head unit (which activates the program-
ming light).
4. Firmly press and release the programmed universal
transceiver button. Press and release the universal trans-
ceiver button a second time to complete the program-
ming process. (Some garage door openers may require
you to do this procedure a third time to complete the
programming.)
Your garage door opener should now recognize your
universal transceiver. You may use either your universal
transceiver or your original hand-held transmitter to
open your garage door.

For Your Security

If you sell your vehicle, be sure to erase the frequencies.
To erase all of the previously programmed frequencies,
hold down channel one and three buttons until
CLEARED CHANNELS is displayed.
NOTE: Individual channels can not be erased. You
must erase all three channels.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
What May Cause The Universal Transceiver Not
To Work
• The universal transceiver may not have been pro-
grammed correctly. Try reprogramming.
• The batteries in the hand-held transmitter may be
weak. New batteries may be required in your hand-
held transmitter.
• Place the hand-held transmitter at a different distance
from the universal transceiver (approximately 1 to 3
inches) (approximately 3 to 8 centimeters) and repro-
gram.
• The frequency of the programmed device's hand-held
transmitter must be between 286MHz and 399MHz,
set by FCC part 15.205. (The back side of the hand-held
transmitter may indicate its frequency.)
• If you are unable to program the universal transceiver
after repeated attempts, you may contact HomeLink
at 1–800–355–3515
www.homelink.com.
or on the internet
3
at