Reprogramming A Single Universal Transceiver Button - Chrysler 2004 300M User Manual

5. To program the other buttons, repeat steps 3 and 4. Be
sure to keep your hand-held transmitters in case you
need to reprogram the universal transceiver.
NOTE: If you do not successfully program the
HomeLink Universal Transceiver to learn the signal of
the hand-held transmitter, refer to Programming Mul-
tiple Security Code Systems (Rolling Code) later in
this text or call toll-free for customer assistance at
1-800-355-3515 or
www.homelink.com.
on the internet
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 83
NOTE: In Canada, D.O.C. regulations require many
hand-held transmitters to stop transmitting after two
seconds. On these hand-held transmitters, transmission
will stop even though the light on the hand-held trans-
mitter stays lit.
If you have one of these hand-held transmitters, you
should press and release the hand-held transmitter
button every two seconds without releasing the uni-
versal transceiver button.
Release both buttons when the display indicates
TRAINED.
Reprogramming a Single Universal Transceiver
Button
1. Press and hold the desired universal transceiver but-
ton for about 20 seconds.
2. When the display indicates TRAINING, position the
hand-held transmitter one to three inches away from the
universal transceiver surface.
at
3. Press and hold the hand-held transmitter button.
3