Browsing To The Gateway; Troubleshooting; How To Perform A Hardware Reset To Factory Defaults; Factory Default Service Settings - Technicolor TG650S Installation Manual

5.4

Browsing to the Gateway

5.4 Browsing to the Gateway
The configuration allows the user to browse the gateway. However, after applying the AT&T
bridge mode configuration there are 2 requirements:
1. the DHCP server on the device has been disabled, so the user must configure the
workstation with a static IP-address in the range 192.168.1.0/24.
2. The user must have the configured username/password to be allowed access to the
gateway. Without it, access is not possible.
How to use the web interface on the Gateway is described in the standard "Setup Guide"
available on the CD-ROM. This can be found in the "Documentation" directory on the CD.
5.5

Troubleshooting

5.5 Troubleshooting
5.5.1

How to perform a hardware reset to factory defaults.

5.5.1 How to perform a hardware reset to factory defaults.
The following steps must be executed:
1. Make sure the gateway is powered on.
2. Use a pen or an unfolded paper-clip to push the recessed reset button on the right side
of the gateway. Keep it pushed until all LEDS go out except for the power led. This will
take about 7-10 seconds.
3. Release the reset button.
4. The gateway restarts in default configuration.
Resetting the system to its factory defaults also involves deleting the configuration profile
settings. Therefore you need to reconfigure the system using the gateway Setup wizard or by
uploading the relevant configuration file.
5.5.2 5.5.2

Factory default service settings

Factory default service settings
When the Gateway leaves the factory and after each hardware reset to manufacturer defaults,
the Gateway features the following factory default settings:
LAN-side IP address: 192.168.1.254
Subnet mask: 255.255.255.0
User name: Administrator
password: not set
DHCP server: enabled on all LAN ports
DNS server: enabled
Master firewall: enabled
Default Connection profile settings:
Transparent Bridging on VPI*VCI=8*35, 0*35 and EFM untagged.
The TG650s uses generic Technicolor firmware with 4 embedded templates:
 Bridge: this template will configure bridge mode configurations.
 Routed IPoA: This will set up the gateway as router asking an IP-address via DHCP.
ATT_TG650s_Quick_Install_Guide Page 27