Nozzle Assembly Cleaning - KRAUSE & BECKER 60446 Owner's Manual & Safety Instructions

Delayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.

Nozzle Assembly Cleaning

Note: The Piston, Spring and Cylinder
are one piece. Do not disassemble.
1. Remove the Nozzle, and then pull
out the Nozzle assembly.
2. Soak all parts in solvent. If necessary, use
a brush (sold separately) and a toothpick.
3. Make sure all parts are free
from residual paint.
piston
Spent Solvent Disposal
After cleaning, dispose of spent solvent according to the solvent
manufacturer's directions and local hazardous waste standards.
Item 60446
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
Spring Cylinder
Lubricant
Holes
Figure K
For technical questions, please call 1-888-866-5797.
4. Rinse with warm water, then
thoroughly dry all parts.
5. Apply a few drops of spray gun
lubricant to lubricant holes.
6. Reassemble the Spray Gun.
Important: When replacing Nozzle assembly,
position the lubricant holes down so they will line
up with lubricant hole under Pump Housing.
Nozzle
Valve
Page 15