Troubleshooting - KRAUSE & BECKER 60446 Owner's Manual & Safety Instructions

Krause & becker 60446 electric paint spray gun
Table of Contents

Advertisement

Delayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.

Troubleshooting

When first filled, the gun may take up to 30 seconds
after the trigger is held to prime and start spraying.
problem
Sputtering Spray
Will Not Spray
Overspray
(Paint drifting to
unintended objects.)
Nozzle Leakage
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power cord and safely discharge pressure before service.
Item 60446
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
possible Causes
1. Low paint level.
2. Container tipped.
3. Loose/damaged Nozzle.
1. No power at Spray Gun.
2. Fluid too thick.
3. Nozzle assembly clogged.
1. Improper application speed.
2. Improper distance from workpiece
1. Dirty Nozzle.
2. Worn or damaged Nozzle.
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Refill.
2. Hold upright.
3. Replace Nozzle.
1. Check Power Cord.
2. Thin fluid.
3. Clean according to Nozzle
Assembly Cleaning
section on page 15.
1. Move moderately
and parallel.
2. Adjust distance.
1. Clean Nozzle.
2. Replace Nozzle.
Page 17

Advertisement

Table of Contents
loading

Table of Contents