Oki C711 Maintenance Manual page 134

Oki Data CONFIDENTIAL
Panel display
ON
Inspection
LINE
(The mark indicates no
lamp
lamp
message in the upper row.)
Varies On
%COLOR% Toner
Sensor Error
Blink Varies
Error Postscript
Varies On
(Off)
%COLOR% Image
Drum Near Life
Varies On
Fuser Unit Near Life
(Off)
44205401TH Rev.1
Remedial
Details
measure
Toner sensor warning:
Indicates the printer has a toner
sensor problem. Be sure the
image drum cartridges and toner
cartridges are properly installed.
Toner sensor error:
Indicates a toner sensor failure
occurred, toner cartridge lever
turning was omitted or an image
drum is not properly installed.
Be sure the toner cartridges and
image drums are properly installed.
Contact an appropriate customer
service center when this error
persists.
Interpreter detects an error due to the
following reason. Receive data after
this is ignored until the job completion.
When the job is completely received,
this is automatically cleared.
- The job has a grammatical error.
- The page is complicated, and VM
was used up.
The life of the drum (warning).
Displayed in a combination of other
message in the first line. The printer
stops at the point when it reaches the
drum life (Shifts to error, OFF-LINE.)
Moreover, when set as Admin Setup
"System Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
%COLOR%
Yellow
Magenta
Cyan
Black
Notifies the fuser unit is near its life.
Moreover, when set as Admin Setup
"System Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
Panel display
ON
LINE
(The mark indicates no
lamp
message in the upper row.)
Varies
Belt Unit Near Life
Varies
Change Fuser Unit
Varies
Change Belt Unit
Varies
− %COLOR% Toner
Empty
Varies
%COLOR% Toner Not
Installed
−
7. Troubleshooting and repair procedure
Inspection
Details
lamp
On Notifies the belt unit is near its life.
This is a warning; thus, printing will
(Off)
not stop.
Moreover, when set as Admin Setup
"System Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
On Notifies the life of the fuser unit
(warning). Displayed in a combination
of other message in the first line.
Warning only (No Life error).
This appears when the cover was
opened and closed just after the
fuser life error occurred.
On Notifies the transfer belt is end of its
life (Warning).
This status message is displayed
when opening/closing a cover or
turning power on again after the
transfer belt life error or belt waste
toner full error occurs.
On Notifies toner is empty.
This status message (warning) is
displayed when opening/closing a
cover or turning power on again after
the toner empty error occurs.
%COLOR%
Yellow
Magenta
Cyan
Black
On Indicates that the toner cartridge is
not installed. This status is warning
only.
%COLOR%
Yellow
Magenta
Cyan
Black
Remedial
measure
−
Replace the
fuser with the
new fuser.
Replace the
belt unit with
the new belt
unit.
Replace
the toner
cartridge with
the new toner
cartridge.
Install
the toner
cartridge. Be
careful that the
toner cartridge
supplied with
the product
cannot be
used if the
toner cartridge
of other supply
is used.
134 /