Oki C711 Maintenance Manual page 130

Oki Data CONFIDENTIAL
Panel display
ON
Inspection
LINE
(The mark indicates no
lamp
lamp
message in the upper row.)
Checking Sectors Off Off
nnn%
Program Update Mode Off Off
Wait a Moment Off Blink
Program Data Received
Wait a Moment Off Off
Program Data Received
OK
Check Data Off On
Program Data Receive
Error
<nnn>
Wait a Moment Off Blink
Program Data Writing
Power Off/On Off Off
Program Data Writing OK
Check Data Off On
Program Data Write Error
<nnn>
44205401TH Rev.1
Details
Displays that a sector of SD Card is being checked.
Check process of the sector is valid to start from
"Storage Setup"-"Check All Sectors" of Boot Menu.
nnn
Percentage of checked capacity
Indicates that the printer has entered in the
dedicated mode for upgrading the NIC program
(controller firmware) version.
Indicates that reception of the NIC program data
for upgrading is in progress.
Indicates that reception of the NIC program data
for upgrading is complete.
Indicates that an error has occurred during
reception of the NIC program data for upgrading.
%DLCODE%
1 : Size error
2 : Checksum error
3 : Printer model number error
4 : Module I/F version error
5 : FAT version error
Indicates that writing of the NIC program data for
upgrading is in progress.
Indicates that writing of the NIC program data for
upgrading is in complete.
Indicates that an error has occurred during writing
of the NIC program data for upgrading.
%DLCODE%
1 : Memory allocation error
2 : Download file error
3 : Device free space acquisition error
4 : Device insufficient free space error
5 : File write error
6 : CU-F/W mismatch error
Panel display
ON
Inspection
LINE
(The mark indicates no
lamp
lamp
message in the upper row.)
PU Flash Error Off Off
Communication Error Off Off
Status Mode Off Off
7. Troubleshooting and repair procedure
Details
Indicates that the PU firmware has started up
in the Loader mode. It is indicated when the PU
firmware has returned "00.00.00" against the
Leisus command "VERSIONR 01H" requesting
(PU) firmware version information supplied from
the CU firmware at power-on. When initialization is
finished, it is switched to the Priority 251 status.
This error can occur in the user environment. If
this error occurs, maintenance by a maintenance
engineer is required. (Same as S/C)
Indicates that communication with the PU firmware
has failed. This error can occur in the user
environment. If this error occurs, maintenance by a
maintenance engineer is required. (Same as S/C)
Indicates that the printer has started in the ON
LINE mode always. When a printer starts up in
this mode, it processes the data (job) from outside
(host) even when an error occurs if a printer has
entered the ON LINE mode once.
Error and warning are displayed on the panel.
A printer can enter in this mode if the power of a
printer is turned on while pressing the switches of
<Enter> + <Back> + <Down> all simultaneously.
Because this pattern of pressing the multiple
switches at the same time at power-on is not
disclosed to user, this status will not occur in the
user environment.
130 /