Warning And Safety Instructions; Building In - Miele KM 400 Installation Instructions Manual

Ceramic hobs; ceramic contact grill; open grill; deep fat fryer

Hide thumbs Also See for KM 400:

Technical information (66 pages)

Operating instructions manual (24 pages)

Product and cut-out dimensions (1 page)

Table Of Contents

Table of Contents

Building in

Fit wall units and the cooker hood

before fitting the appliance, to avoid

damaging it.

The veneer or laminate coatings of

worktops (or adjacent kitchen

units) must be treated with 100 °C heat

resistant adhesive which will not

dissolve or distort. The worktop

upstand must be heat-resistant.

Ideally the appliances should be

installed with plenty of space on

either side. There may by a wall at the

rear and a wall or tall units at one side.

On the other side, however, no unit or

divider may stand higher than the

appliance (see illustrations).

An electric fryer must not be

installed next to a gas hob, as the

gas flames could ignite the fat in the

fryer. It is essential to maintain a safety

distance of at least 288 mm between

these two appliances.

Due to the heat radiated by the

appliance and to allow cooking

fumes to dissipate it is essential that

a minimum safety distance a is

maintained between the worktop

cut-out and adjacent kitchen units,

e.g. a tall unit, as follows:

KM 400, KM 402, KM 403, KM 412

KM 418 = 40 mm

KM 408-1 = 50 mm

KM 410 / KM 411 = 250 mm

There must be a minimum safety

distance of 50 mm between the hob

and a back wall.