Enable A Test Pattern - Red Epic 4K Broadcast Module Operation Manual

R E D 4 K B R O A D C A S T M O D U L E O P E R AT I O N G U I D E
6. Set up the genlock source in the camera:
A. Go to Menu > Settings > Setup > GPIO/Sync.
B. Select Rear Module from the Genlock Source drop-down menu.
The GEN indicator in the Lower Status Row illuminates green.

ENABLE A TEST PATTERN

1. Go to Menu > Settings > Display > 4K Broadcast.
2. Select Test Pattern from the right Output drop-down menu.
The SDI ports output SMPTE color bars.
3. To switch back to the video feed, select Video from the right Output drop-down menu.
COPYRIGHT © 2015 RED.COM, INC 955-0072, REV-E | 16