Pc Connection - LG GSA-4120B Owner's Manual

NOTE : Only one jumper should be installed on the jumper connector.
If more than one jumper is installed, the drive may malfunction or be damaged.
Master/Slave setting is determined by jumper installation on the Jumper Connector.
The following table shows the possible jumper settings.
Name Function
MA
Drive set as Master
(Master)
Drive set as Slave
SL
(Slave)
Drive mode set by CSEL on the host IDE
CS
interface
(Cable Select)
If you use CSEL setting, the MASTER/SLAVE setting will be made automatically,
depending on the hardware configuration. For more details refer to the manual of your
computer.

PC Connection

The Super Multi DVD Drive connects to the motherboard of the host computer using an
IDE interface cable. You may connect the Super Multi DVD Drive as a Slave or Master
device, depending on your computer.
To Install as a Master Drive
To install the drive as a Master, the jumper can be left as supplied from the factory.
Master drive
Master drive
(Super Multi DVD Drive)
(Booting hard disk)
(Jumper left as Master)
Primary
connector
NOTE : A hard disk is normally installed as the Primary Master on the EIDE (ATAPI)
interface. Other EIDE peripheral devices such as hard drives and Super Multi DVD Drives
are then set differently.
Master drive
(Booting hard disk)
- OR -
Motherboard
Primary
connector
Secondary
connector
5
C S M
S L A
Master drive
(Super Multi DVD Drive)
(Jumper left as Master)
Slave drive
(Other IDE
drive)
Secondary
connector