Download  Print this page

Pc Connection - LG GH22LP20 Owner's Manual

Gh22 series super multi dvd rewriter
Hide thumbs

Advertisement

NOTE : Only one jumper should be installed on the jumper connector.
If more than one jumper is installed, the drive may malfunction or be damaged.
Master/Slave setting is determined by jumper installation on the Jumper Connector.
The following table shows the possible jumper settings.
Name
Function
Drive set as Master
MA (Master)
SL (Slave)
Drive set as Slave
CS
Drive mode set by CSEL on the host IDE interface
(Cable Select)
If you use CSEL setting, the MASTER/SLAVE setting will be made automatically,
depending on the hardware configuration. For more details refer to the manual of
your computer.

PC Connection

The Super Multi DVD Rewriter connects to the motherboard of the host computer
using an IDE interface cable. You may connect the Super Multi DVD Rewriter as a
Slave or Master device, depending on your computer.
To Install as a Master Drive
To install the drive as a Master, the jumper can be left as supplied from the factory.
Master drive (Super
Master drive
Multi DVD Rewriter)
(Booting hard disk)
(Jumper left as Master)
Motherboard
Primary
connector
NOTE : A hard disk is normally installed as the Primary Master on the EIDE (ATAPI)
interface. Other EIDE peripheral devices such as hard drives and Super Multi DVD
Rewriters are then set differently.
Master drive
(Booting hard disk)
- OR -
Primary
connector
Secondary
connector
5
C
S
M
S
L
A
Master drive (Super
Multi DVD Rewriter)
(Jumper left as Master)
Slave drive
(Other IDE
drive)
Secondary
connector

Advertisement

loading

  Also See for LG GH22LP20

  Related Manuals for LG GH22LP20

This manual is also suitable for:

Gh22np20