Tips; Maintenance & Servicing - Homeright Power-Flo Pro 2800 Instruction Manual

MAINTENANCE AND SERVICING
IMPORTANT: Procedures not specifically explained in this manual must be performed only by
a qualified technician.
m WARNING
To Prevent Serious Injury From Accidental Operation
Prior to cleaning, lock the Gun Trigger, turn the Pressure Adjust Knob to "OFF", then open the
Prime/Spray Knob to release all pressure.
Prior to storing or performing service and repairs, turn the Power Switch of the Sprayer to
its "OFF" position, unplug the Sprayer from its electrical outlet, and relieve all remaining
pressure from the system.
m WARNING
To Prevent Serious Injury From Tool Failure
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem
corrected before further use.
Before each use, inspect the general condition of the Airless Sprayer. Check for loose
screws, misalignment or binding parts, cracked or broken parts, damaged electrical wiring,
damaged hoses and any other condition that may affect its safe operation,
To Clear the Spray Tip
If Spray Tip clogs while spraying, rotate the Tip 180° to the "Clean position. (Figure M)
Pull the Trigger and spray to clear the Tip of any blockage. Take care to spray away from
workpiece in order to clear the clog. Rotate the Tip back to the "Spray" position and
continue spraying. (Figure N ) If the clogging continues, clean or replace the Spray Gun Filter.
(Figure P )
IMPORTANT: Do not use a needle or sharp object to clean the Tip, as damage to the Tip
may result.
To Change Spray Tips
Rotate the Spray Tip 90º. Remove the Spray Tip from the Nozzle Seat. Install a new Spray Tip
on the Nozzle Seat. Then rotate the Tip 90º to the "spray" position. (Figure N )
To Clean Spray Gun Filter
Unscrew the Spray Gun Handle (Figure O ) from the Gun Body to access the Filter. (Figure P )
Remove the Filter and use brush (not included) to clean with water (if used with water-based
paint) or solvent (if used with oil-based paint). Inspect Filter for pinholes, clogging, or other
damage. Replace if necessary. Reinstall the Filter. Then screw the Spray Gun Handle back
into the Gun Body. (Figure O )
MAINTENANCE AND SERVICING
800879 POWER-FLO PRO 2800
®
12
M
Tip
Clean Position
N
Tip
Spray Position
O
P
ENGLISH