Operating - Homeright Power-Flo Pro 2800 Instruction Manual

IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text
under subheadings therein before set up or use of this product.
Preparing a New Sprayer
Always keep the trigger lock on the spray gun in the locked position while preparing the
system. (Figure F )
• Place the suction tube into a container of soapy water.
• Place the return tube into a metal waste container.
• Turn Pressure Control Knob all the way left (counter-clockwise) to minimize pressure.
(Figure B , page 9)
• Move the Prime/Spray valve down to the Prime position.
• Turn the unit on by moving the On/Off switch to On. (Figure C , page 9)
• Turn Pressure Control Knob to right to start pump.
• Allow the sprayer to run for 15-30 seconds to flush the test fluid out through the return
hose and into the waste container.
• Turn the unit off by moving the On/Off switch to Off. (Figure C , page 9)
• Submerge suction tube in paint. Turn Power Switch ON, and trigger gun into waste pail.
When paint comes out of return tube, turn Prime/Spray valve to SPRAY. When paint comes
out of gun, release trigger. Pump will build up pressure and motor will stop.
• Transfer return tube to paint pail.
• Attach spray tip and guard. Do not over tighten.
• Sprayer is now ready for start up.
Workpiece and Work Area Set Up
• Designate a work area that is clean and well-lit. The work area must not allow access by
children or pets to prevent injury and distraction.
• Route the Power Cord along a safe route to reach the work area without creating a tripping
hazard or exposing the Power Cord to possible damage. The Power Cord must reach the
work area with enough extra length to allow free movement while working.
• There must not be hazardous objects such as utility lines or foreign objects nearby that
will present a hazard while working.
GENERAL OPERATING INSTRUCTIONS
NOTE: Prior to use, add approximately 5 drops of machine oil (Figure G ). Adding this oil is a
daily requirement each time the Spray Gun is used.
Prior to operating the Sprayer, know in advance how to release pressure in the unit's system:
• Engage the Safety Lock on the Spray Gun. (Figure F )
• Turn the Power Switch to its "OFF" position. (Figure C , page 9)
• Turn the Pressure Adjust Knob to it's lowest setting. (Figure B, page 9)
• Unlock the Spray Gun by turning the Safety Lock to the unlocked position. (Figure F )
• Hold the Spray Gun firmly against the side of a grounded container. (Figure H )
• Spray the paint into the container to relieve the system pressure.
• Lock the Spray Gun by turning the Safety Lock to the locked position. (Figure F )
• Turn the Prime/Spray Knob to its "PRIME" position. (Figure D , page 9)
HOW TO USE
800879 POWER-FLO PRO 2800
®
10
F
G
H
Add Oil
ENGLISH