The Connections On The Rear Panel - Viscount Chorale 8 User Manual

Chorale 8
Viscount

2.6 THE CONNECTIONS ON THE REAR PANEL

In the bottom of the rear panel there are two more pairs of line audio outputs, an optional amplified stereo
output, and the power supply socket for the connected loudspeakers.
The main difference between these outputs and the ones in the recess underneath the manuals is that the
latter contain the signal generated by the organ, while on the rear connectors, the signals of the individual
manuals and pedal board are routed to and adjusted on the individual outputs in accordance with the
relative settings on the display (for more information see points 7.3, 7.4 and 7.5).
1. [EXT. +12V DC] connectors: these sockets can be used to obtain the +12V DC voltage needed to supply
the VISCOUNT speakers connected to the [AUX OUT] outputs
2. [AUX OUT 1] and [AUX OUT 2] connectors: Jack line outputs carrying the organ signal in
accordance with the routing set by means of the function on display. With the Factory Settings active,
the signals are distributed as follows:
- [AUX OUT 1]: General signal
- [AUX OUT 2]: Reverb only
3. [SPEAKER OUT] connectors: amplified stereo output to which a pair of passive loudspeakers can
be connected. In Factory Setting mode, the amplified general organ signal can be obtained from these
outputs. The optional internal amplifier must be installed to allow use of these outputs. Contact your
dealer for more information.
N.B.
For installation, connection and setup of the internal amplifier refer to the installation guide in the
optional's packaging.
EXT. L(+R) R
+12V DC
300 mA
-
+
AUX OUT 1
1 2
12
OPTIONAL
L(+R) R L R
AUX OUT 2 SPEAKER OUT 8
3
Owner's Manual