Device Settings - Symmetricom ND-SERIES User Manual

Device Settings

Each network clock can be configured to display time (or date) in the format that you prefer, using
time zone offsets and DST settings to completely customize it relative to UTC time. The device
settings window will display the title "NTP Clock Configuration" in the title bar of the window.
Any changes made in this window will not be applied until you click the OK button to exit the
window or the Apply button to immediately see the changes.
The top right section of the Window shows a snapshot of the ND display, constantly updated. This
update is not precise, but is meant to give you a view of the clock display for troubleshooting and
maintenance purposes.
–
Allows for setting the NTP mode and parameters of the SNTP client in the network
Network Time Protocol [NTP] Parameters
clock. These settings are located in the upper left hand section of the device settings window
The Primary Source information must be configured in order to acquire time from an NTP source. Enter either the IP
address or Internet address (URL) for the NTP source. If available, enter a Secondary Source for backup.
The primary and secondary server information can automatically be configured by the DHCP server when selecting the
"Use NTP server(s) address provided by DHCP server" provided your DHCP server is configured to do so. Consult
your IT /Network Administrator to utilize this option.
®
ND Clocks User Manual - Rev 2.0.1 Sep-08 13 Symmetricom , Inc.