Page 3
User’s Manual ‘SP’ Models based upon the CA Series Thank you for your decision to buy a Kling & Freitag sound system. To guarantee a trouble-free operating of the equipment and to allow the KLING & FREITAG -- - ‘SP’ speaker system to achieve its full potential please read the operating instructions care- fully before use.
10. Operating the Speakers 11. Touching Up Damage to Paint / Changing the Front Foam 12. Block Diagram of the SP Full-Range Speaker 13. Technical Specifications 13.1 CA 1001 - SP 13.2 CA 1201 - SP 13.3 CA 1215-6 - SP 13.4...
Page 5
User’s Manual ‘SP’ Models based upon the CA Series Chapter Page 14. Measuring Charts 14.1 CA 1001 - SP 14.2 CA 1201 - SP 14.3 CA 1215-6 - SP 14.4 CA 1215-9 - SP 14.5 CA 1515-6 - SP 14.6 CA 1515-9 - SP 15.
User's Manual ‘SP’ Models based upon the CA Series 1. General Safety Instructions CAUTION Risk of electric shock! Do not open the units! Warning: To avoid electric shock hazard, do not expose this appliance to rain or moisture. The enclosures may only be opened by qualified personnel! Do not install devices in any of the following places: −...
User’s Manual ‘SP’ Models based upon the CA Series Maintenance and technical service The user should not perform any maintenance work on the equipment other than that which is described in this manual. Repairs should be executed by a qualified service technician only.
User's Manual ‘SP’ Models based upon the CA Series 2. Introduction SP Loudspeakers ‘SP’ denotes a new option for selected models in the K&F range of loudspeakers. Based on selected K&F speaker systems, the ‘SP’ models are equipped with state-of- the-art integrated driver circuits and Class D power amplifier technology.
Page 9
(EQ), etc. The following K&F ‘SP’ speakers are available: Full-range systems: CA 1001 - SP, CA 1201 - SP, CA1215-6 - SP, CA 1215-9 - SP CA 1515-6 - SP, CA 1515-9 - SP...
User's Manual ‘SP’ Models based upon the CA Series 3. Connectors, Controls und Displays 1) LINE IN and LINE OUT (+6 dB) Electronically balanced input and output connectors. Use the XLR female connector (marked ‘IN’) as input. The parallel-wired XLR male connector (‘OUT’) is for connec- tion to further ‘SP’...
Page 11
User’s Manual ‘SP’ Models based upon the CA Series 4) GAIN CONTROL (± 6 dB) a) The gain control can be used to adjust the input level of the amplifier module by ± 6dB. It serves to balance the volume levels of the various systems. In or- der to avoid overloading the input circuit or mixer’s output circuit, it should normally be set in the case of K&F full-range systems at 0 dB (centre notch setting).
Page 12
User's Manual ‘SP’ Models based upon the CA Series 6) LED POWER ON (GREEN) and LIMIT / PROTECT (RED) The LED is dual-purpose: a) When the LED is green, the speaker is connected to the supply voltage and ready for operation b) The LED will turn red if…...
User’s Manual ‘SP’ Models based upon the CA Series 7) AC MAINS ‘IN’ Connect this PowerCon socket using the mains cable supplied to a max. 16 A fused mains socket, paying particular attention to the stated mains voltage! Connection to an incorrect mains voltage can result in irreparable damage! Important 8) AC MAINS ‘OUT’...
User's Manual ‘SP’ Models based upon the CA Series 5. Instructions for Suspending the Speakers Only trained personnel may suspend speaker systems. Pay attention the accompanying safety and assembly instructions carefully as well as the required safety factors. Please follow the corresponding national safety regulations.
User’s Manual ‘SP’ Models based upon the CA Series Us Us Using the ‘allsafe JUNGFALK’ Flying Points ing the ‘allsafe JUNGFALK’ Flying Points ing the ‘allsafe JUNGFALK’ Flying Points ing the ‘allsafe JUNGFALK’ Flying Points Single Stud Fitting ‘allsafe JUNGFALK’ flying point Used as fastener to the ‘allsafe Receptacle for special fasteners.
DEFINITION: Horn not rotated Horn rotated Standing speaker: Model CA 1001 - SP 85° h x 55° v 55° h x 85° v CA 1201 - SP 90° h x 60° v 60° h x 90° v CA 1215-6 - SP 65°...
User’s Manual ‘SP’ Models based upon the CA Series 7. Mounting Instructions for Speakers Mount the speakers securely. To avoid injury or damage, always be sure to mount the speakers securely so that they do not fall. Speakers, which are stacked, must be secured with securing straps.
User's Manual ‘SP’ Models based upon the CA Series Arrayed Speaker Systems (Cluster) If the loudspeakers are operated through the optional K&F C2 System Controller, we recommend to turn on the 'Top Low Cut' switch for clustered operation. Thus the fre- quency response for this application can be optimised (see also K&F C2 user's manual).
User’s Manual ‘SP’ Models based upon the CA Series 7.2.2 With rotated Horn Winkel 2 Winkel 3 Horn rotated Standing speaker A smaller angle 3 results in a smaller Winkel 1 vertical coverage angle but increases the sound power level. Combination Angle 1 Angle 2...
User's Manual ‘SP’ Models based upon the CA Series 8. Wiring Before connecting your SP system as shown in chapter 9, be sure to switch off all con- nected appliances and turn down all level controls. − We recommend the use of high-quality cables provided by KLING & FREITAG. −...
User’s Manual ‘SP’ Models based upon the CA Series Connecting the Power Connectors to the Connecting Terminal Only use the supplied power cable and connect it to a mains outlet with a 16 A fuse. Warning See instructions in chapter 4 ‘Power Cord’ on page 13. 9.
User's Manual ‘SP’ Models based upon the CA Series 9.1.2 Full-Range Mode with Subwoofer You can link the input signal (for example from the mixer) from one loudspeaker to another. It makes no difference whether the input signal reaches the bass speaker first and is then transmitted to the mid-high speaker or the other way around.
User’s Manual ‘SP’ Models based upon the CA Series Operations with C2 Controller The frequency range of the SP speakers with filters switched off (FILTERS 'OFF') is 100% identical to the frequency range of the corresponding K&F speakers without SP module (in the case of subwoofers the models without XO).
User's Manual ‘SP’ Models based upon the CA Series 9.2.2 2-Way Active Mode with K&F Controller C2 The switch ‘FILTERS’ on the SP speaker must be at ‘OFF’ in this mode. The ‘Sense’ cables on the C2 Controller do not need to be connected as the SP speakers have their own limiters! The countersunk switch ‘Full-Range Mode’...
User’s Manual ‘SP’ Models based upon the CA Series Maximum Configuration It is possible to use a large number of SP speakers in parallel simultaneously, however, this number is limited according to the permitted minimum load impedance of the sig- nal source (e.g.
User's Manual ‘SP’ Models based upon the CA Series 10. Operating the Speakers − Switch off all equipment and make sure that the SP speakers are not connected to a power source. − Connect your SP systems in accordance with the preceding connection diagrams. Use only mains cables, which comply with your national safety regulations.
User's Manual ‘SP’ Models based upon the CA Series 13. Technical Specifications 13.1 CA 1001 - SP Loudspeaker Design 2-way full-range system with integrated driver and power amplifier technology, bass reflex tuning Frequency range -10 dB 53 Hz - 20 kHz (‘FILTERS OFF’) Frequency range ±3 dB...
User’s Manual ‘SP’ Models based upon the CA Series 13.2 CA 1201 - SP Loudspeaker Design 2-way full-range system with integrated driver and power amplifier technology, bass reflex tuning Frequency range -10 dB 54 Hz - 19 kHz ('FILTERS OFF') Frequency range ±3 dB 65 Hz - 18 kHz ('FILTERS ON' and 'FILTERS OFF') Nominal coverage angle...
User's Manual ‘SP’ Models based upon the CA Series 13.3 CA 1215-6 - SP Loudspeaker Design 2-way full-range system with integrated driver and power amplifier technology, bass reflex tuning Frequency range -10 dB 62 Hz - 22 kHz ('FILTERS OFF') Frequency range ±...
User’s Manual ‘SP’ Models based upon the CA Series 13.4 CA 1215-9 - SP Loudspeaker Design 2-way full-range system with integrated driver and power amplifier technology, bass reflex tuning Frequency range -10 dB 58 Hz - 22 kHz ('FILTERS OFF') Frequency range ±...
User's Manual ‘SP’ Models based upon the CA Series 13.5 CA 1515-6 - SP Loudspeaker Design 2-way full-range system with integrated driver and power amplifier technology, bass reflex tuning Frequency range -10 dB 47 Hz - 22 kHz ('FILTERS OFF') Frequency range ±...
User’s Manual ‘SP’ Models based upon the CA Series 13.6 CA 1515-9 - SP Loudspeaker Design 2-way full-range system with integrated driver and power amplifier technology, bass reflex tuning Frequency range -10 dB 48 Hz - 22 kHz ('FILTERS OFF') Frequency range ±...
User's Manual ‘SP’ Models based upon the CA Series 14. Measuring Charts 14.1 CA 1001 - SP Frequency response ‘on axis’ Filters 'OFF' Filters 'ON' 1000 10000 20000 Frequency (Hz) Frequency response ‘on axis’ with K&F Controller C2 (Filters ‘OFF’)
User's Manual ‘SP’ Models based upon the CA Series 14.2 CA 1201 - SP Frequency response ‘on axis’ Filters 'OFF' Filters 'ON' 1000 10000 20000 Frequency (Hz) Frequency response ‘on axis’ with K&F Controller C2 (Filters ‘OFF’) Fullrange 2-Way TopLowCut / Fullrange TopLowCut / 2-Way High Boost 1000...
User's Manual ‘SP’ Models based upon the CA Series 14.3 CA 1215-6 - SP Frequency response ‘on axis’ Filters 'OFF' Filters 'ON' 1000 10000 20000 Frequency (Hz) Frequency response ‘on axis’ with K&F Controller C2 (Filters ‘OFF’) Fullrange 2-Weg TopLowCut / Fullrange TopLowCut / 2-Weg High Boost 1000...
User's Manual ‘SP’ Models based upon the CA Series 14.4 CA 1215-9 - SP Frequency response ‘on axis’ Filters 'OFF' Filters 'ON' 1000 10000 20000 Frequency(Hz) Frequency response ‘on axis’ with K&F Controller C2 (Filters ‘OFF’) Fullrange 2-Weg TopLowCut / Fullrange TopLowCut / 2-Weg High Boost 1000...
User's Manual ‘SP’ Models based upon the CA Series 14.5 CA 1515-6 - SP Frequency response ‘on axis’ Filters 'OFF' Filters 'ON' 1000 10000 20000 Frequency(Hz) Frequency response ‘on axis’ with K&F Controller C2 (Filters ‘OFF’) Fullrange 2-Weg TopLowCut / Fullrange TopLowCut / 2-Weg High Boost 1000...
User's Manual ‘SP’ Models based upon the CA Series 14.6 CA 1515-9 - SP Frequency response ‘on axis’ Filters 'OFF' Filters 'ON' 1000 10000 20000 Frequency(Hz) Frequency response ‘on axis’ with K&F Controller C2 (Filters ‘OFF’) Fullrange 2-Weg TopLowCut / Fullrange TopLowCut / 2-Weg High Boost 1000...
User's Manual ‘SP’ Models based upon the CA Series 15. Dimensions 15.1 CA 1001 - SP Gewindeeinsatz M8 für Stativadapter & TV-Zapfenadapter Flugpunkt Gewindeeinsatz M10 99 mm 115 mm Flugpunkt [3.898"] [4.528"] Gewindeeinsatz M10 Flugpunkt Gewindeeinsatz M10 313 mm 156 mm 307 mm [12.323"]...
User’s Manual ‘SP’ Models based upon the CA Series 15.3 CA 1515-6/-9 -- - SP Flugpunkte ANCRA Jungfalk 120030-31 Kunststoff- Gleitf üße 433.6 mm 411.3 mm 212.3 mm [17.073 inch] [16.195 inch] [8.358 inch] Hochst änder- buchse 73° K&M 19656 48°...
Page 48
User's Manual ‘SP’ Models based upon the CA Series Adjustable Speaker Mount CA 1201/CA1215 Cradle 1201/CA1215 Adjustable Speaker Mount CA 1515 Cradle 1515 Multi Cradle CA 1201/CA1215 Wall Mount, Multi Cradle CA 1515 tiltable, max. 50 kg Schwenkbügel Stativadapter Distanzrohr Distance rod &...
User’s Manual ‘SP’ Models based upon the CA Series 17. Regulations for Disposal 17.1 Germany: It is not allowed to dispose of used electrical equipment as domestic waste. But please do not dispose of them at official collecting points for recycling either! All Kling &...
Kind of equipment: Loudspeaker systems with integrated amplifier(s) Type-designation: CA 1001 - SP, CA 1201 - SP, CA 1215-6 - SP, CA 1215-9 - SP, CA 1515-6 - SP, CA 1515-9 - SP,...
User’s Manual ‘SP’ Models based upon the CA Series 18.3 TÜV Certificate for the USA and Canada (UL 6500) TÜV Certificate for the USA and Canada (UL 6500) TÜV Certificate for the USA and Canada (UL 6500) TÜV Certificate for the USA and Canada (UL 6500) KLING &...
Need help?
Do you have a question about the CA 1001 - SP and is the answer not in the manual?
Questions and answers