Alcolock* - To Bear In Mind - Volvo V40 Cross Country Owner's Manual

08 Starting and driving

Alcolock* - to bear in mind

In order to obtain correct function and as
accurate a measurement result as possible:
•
Avoid eating or drinking
approx. 5 minutes before the breath test.
•
Avoid excess windscreen washing - the
alcohol in the washer fluid may result in
an incorrect measurement result.
Change of driver
In order to ensure that a new breath test is
carried out in the event of a change of driver -
depress the switch (2) and the send button (3)
simultaneously for approx. 3 seconds. At
which point the car returns to start inhibition
mode and a new approved breath test is
required before starting the engine.
Calibration and service
The Alcolock must be checked and calibrated
2
at a workshop every 12 months.
30 days before recalibration is necessary the
combined instrument panel shows the mes-
Alcoguard Calibration required See
sage
manual
. If calibration is not carried out within
these 30 days then normal engine starting will
be blocked - only starting with the Bypass
function will then be possible, see the follow-
ing heading "Emergency situation".
The message can be cleared by pressing the
08
send button (3) once. Otherwise it goes out
An authorised Volvo workshop is recommended.
2
*
264
Option/accessory, for more information, see Introduction.
on its own after approx. 2 minutes but then
reappears each time the engine is started -
only recalibration at a workshop
the message permanently.
Cold or hot weather
The colder the weather the longer it takes
before the Alcolock is ready for use:
Temperature (ºC) Maximum heat-
ing time (sec-
onds)
+10 to +85
-5 to +10
-40 to -5
At temperatures below -20 ºC or above
+60 ºC the Alcolock requires additional power
supply. The combined instrument panel
Alcoguard Please insert power
shows
cable
. In which case, connect the power
supply cable from the glovebox and wait until
indicator lamp (6) is green.
In extremely cold weather the heating time
can be reduced by taking the Alcolock
indoors.
Emergency situation
In the event of an emergency situation or the
2 can clear
Alcolock is out of order, it is possible to
bypass the Alcolock in order to drive the car.
NOTE
All activation with bypass is logged and
saved in a memory; see Recording data
(p. 18).
After the bypass function has been activated
the combined instrument panel shows
Alcoguard Bypass enabled
10
while driving and can only be reset by a work-
60
2
shop .
180
The Bypass function can be tested without
the error message being logged - in which
case, carry out all the steps without starting
the car. The error message is cleared when
the car is locked.
When the Alcolock is installed, either the
Bypass or Emergency function is selected as
the bypassing option. This setting can be
changed afterwards at a workshop
Activating the Bypass function
•
Depress and hold the left-hand stalk
switch OK button and the button for haz-
ard warning flashers simultaneously for
approx. 5 seconds - the combined instru-
ment panel first shows
the whole time
2 .
Bypass activated