Table of Contents
Advertisement
The navigation keys at the bottom of the screen allow you to move through the menus
and select the menu options.
The RAID BIOS setup screens shown in this section are for reference only and may not
exactly match the items on your screen.
The utility supports maximum four hard disk drives for RAID coniguration.
Creating a RAID set
To create a RAID set:
1.
From the utility main menu, select 1. Create RAID Volume and press <Enter>. The
following screen appears:
[↑↓]Change
2.
Enter a name for the RAID set and press <Enter>.
3.
When the RAID Level item is selected, press the up/down arrow key to select a RAID
level to create, and then press <Enter>.
4.
When the Disks item is selected, press <Enter> to select the hard disk drives you want
to include in the RAID set. The SELECT DISKS screen appears:
Port Drive Model
0
ST3160812AS
1
ST3160812AS
2
ST3160812AS
3
ST3160812AS
[ ↑↓ ]-Prev/Next [SPACE]-SelectDisk [ENTER]-Done
5-4
Intel(R) Rapid Storage Technology - Option ROM - v3.0.0.1184
Copyright(C) 2003-11 Intel Corporation.
RAID Level:
Strip Size:
Capacity:
Enter a unique volume name that has no special characters and is
[TAB]-Next
[ SELECT DISKS ]
Serial #
9LS0HJA4
9LS0F4HL
3LS0JYL8
9LS0BJ5H
Select 2 to 6 disks to use in creating the volume.
[
CREATE VOLUME MENU
Name:
Volume0
RAID0(Stripe)
Disks:
Select Disks
128KB
0.0
GB
Sync:
N/A
Create Volume
[
HELP
]
16 characters or less.
[ESC]-Previous Menu
Size
Status
149.0GB
Non-RAID Disk
149.0GB
Non-RAID Disk
149.0GB
Non-RAID Disk
149.0GB
Non-RAID Disk
All Rights Reserved.
]
[ENTER]-Select
Chapter 5: RAID coniguration
Advertisement
Table of Contents
