Table of Contents
Advertisement
2.7.2
Removing the HDD module cage
1.
Disconnect the all cables from the SATA backplane on the HDD module cage.
2.
Level the HDD module cage latch
counterclockwise. The HDD module
cage will be pushed out of the chassis.
3.
Completely pull out the HDD module
cage.
2.7.3
Installing a hot-swap SATA hard disk drive
1.
Release a drive tray by pushing the
spring lock to the right, and then pulling
the tray lever outward. The drive tray
ejects slightly after you pull out the lever.
2-16
2
Chapter 2: Hardware setup
Advertisement
Table of Contents
